firewall builder ddwrt ip link not working

Firewall builder ddwrt ip link not working how to#

Once the AP is finally passing traffic I still have problems After a few hours of no activity the AP will not pass any traffic to the outside and I can no longer ping 192.168.1.1 on any wired or wirelessly connected device or through the telnet console.When I ping google directly wired to the AP the ping times are all over the place spiking as high as 1000ms and as low as 8ms.If I wire a laptop to one of the other 5 ports on the AP I can not ping 192.168.1.1 until I ping an external server like google DNS (8.8.8.8).Pinging from the Telnet console of the AP I can almost never ping 192.168.1.1 and I can only ping 192.168.1.1 after I have pinged an external source with a another device connected to it the AP. NTP Client enabled server IP: 192.168.1.1.the subnet mask is of course 255.255.255.0.The local ip address: 192.168.1.251( this is outside the DHCP range set on the sophos.The WAN connection type is set to disable.Here are a list of all the settings I changed bellow on the AP: However, the “Assign WAN Port to Switch” box is checked. The AP is connected to the 24 port switch and it is connected to the WAN port. The AP however, is a pain in my rear end. All wired and wireless devices are on the same subnet. Sophos hosts DHCP, DNS, and provides the network with UTM functions. All wired devices connected to the switch work as intended and sophos is amazing. The AP is a wrt54g linksys router running DD-WRT. The lan nic on the Dell 850 goes to a 24 port GB switch. My gateway is currently sophos running virtually on ESXi 5.5. I have done 10 hours of reading on the subject before I create a useless thread. I am going to provide as much detail as possible to yield a helpful answer. except you want the bridge to also handle DHCP.Setting up an access point should be easy, however I have been having issues with mine. You are essentially turning the router into a bridge.

Firewall builder ddwrt ip link not working how to#

Otherwise, follow the link in the above answer, or use the DD-WRT Support site and follow their instructions for how to manually configure the router. if not also the internal IP address itself as well. This means that when you connect a router to the DSL modem, you usually have to manually assign the gateway address of this Private Network to the router. What that means is if you check the IP address that is assigned to the computer connected to the DSL modem, it would be a Private Network address. I apologize to the holder of that address, whomever it may be.

You typically see an address like 192.168.2.1 or something similar coming out of the DSL modem, as opposed to an external IP address like 69.172.43.86 or whatnot (I just created that randomly. They tend to be hard coded to pass out a single internal IP address to a device that is connected to them. The issue here is in how DSL modems work.ĭSL modems typically have router firmware built into them. As was mentioned in the earlier answer, the key here is manually setting up your internet connection in the router.